Finally we were able to print an awesome 3d Hand. The heat issue that we have on our 3d printer caused some dodgy results. Some of them are,
However after fine tuning the 3d printer we managed to print a complete 3d hand (Thank you Andrew \m/). Used rubber pieces for the hinges as the 3d printer doesn't support the flexible materials. It was bit of a challenge to shape those rubber pieces and also to drill the fingers so that we can put the thread in. Also I had to sand the sides of the fingers so that it has less friction for the movement. Here are some photos.
It already has a lot of fans. :)
GREAT JOB GUYS!
However after fine tuning the 3d printer we managed to print a complete 3d hand (Thank you Andrew \m/). Used rubber pieces for the hinges as the 3d printer doesn't support the flexible materials. It was bit of a challenge to shape those rubber pieces and also to drill the fingers so that we can put the thread in. Also I had to sand the sides of the fingers so that it has less friction for the movement. Here are some photos.
It already has a lot of fans. :)
No comments:
Post a Comment